[Nov 30, 2021] New Updated 1Y0-241 Exam Questions 2021
Updated Free Citrix 1Y0-241 Test Engine Questions with 65 Q&As
Citrix 1Y0-241: Deploy and Manage Citrix ADC 13 with Traffic Management Exam Certification Path
The Citrix ADC 12 Essentials and Traffic Management exam certification include only one 1Y0-241 certification exam. Preparation for any certification could be challenging if the candidate has not done the proper planning and haven’t used relevant study material source. On the internet candidate would be finding lots of ebook or material to study but the problem which one they should refer to and how to identify which one is genuine. To overcome this challenging phase, PDF4Test came with their study plan covering course contents specific to Citrix 1Y0-241: Deploy and Manage Citrix ADC 13 with Traffic Management exam in the form of Citrix 1Y0-241 practice exams and Citrix 1Y0-241 exam dumps.
NEW QUESTION 30
Scenario: A Citrix Administrator executed the following command in a global server load balancing (GSLB) environment:
set gslb site SiteB -triggerMonitor MEPDOWN
What will be the effect of this command on the default service monitoring behavior on a remote site?
- A. The service monitor will take precedence over Metric Exchange Protocol (MEP).
- B. The state of the GSLB service will always be controlled by Metric Exchange Protocol (MEP).
- C. The service monitor is invoked only when Metric Exchange Protocol (MEP) connectivity has been lost between Site A and Site B.
- D. The service monitor is invoked only when Metric Exchange Protocol (MEP) has marked the service as DOWN.
Answer: D
NEW QUESTION 31
Scenario: A Citrix ADC receives packets destined for a MAC address owned by the Citrix ADC. The destination IP address of the packets does NOT belong to the Citrix ADC. Layer 3 mode is enabled by default on the Citrix ADC.
The Citrix ADC will __________ the packets in this scenario. (Choose the correct option to complete the sentence.)
- A. process
- B. drop
- C. bridge
- D. route
Answer: D
Explanation:
Explanation/Reference:
Reference: https://docs.citrix.com/en-us/citrix-adc/current-release/getting-started-with-citrix-adc/configure- system-settings/configure-modes-packet-forwarding.html
NEW QUESTION 32
Scenario: A Citrix Administrator manages an environment that has a Citrix ADC high availability (HA) pair running on two MPX appliances. The administrator notices that the state of the secondary Citrix ADC is
'Unknown'.
What is causing the secondary state to be 'Unknown'?
- A. The synchronization on the secondary appliance is disabled.
- B. TCP port 22 is disabled between the primary and secondary ADCs.
- C. The administrator made both Citrix ADCs primary.
- D. The remote procedure call (RPC) nodes are incorrectly configured.
Answer: D
NEW QUESTION 33
Scenario: A Citrix Administrator configured an authentication, authorization, and auditing (AAA) policy to allow users access through the Citrix ADC. The administrator bound the policy to a specific vServer.
Which policy expression will allow all users access through the vServer?
- A. true
- B. ns_false
- C. false
- D. ns_true
Answer: A
NEW QUESTION 34
Scenario: A Citrix ADC receives packets destined for a MAC address owned by the Citrix ADC. The destination IP address of the packets does NOT belong to the Citrix ADC. Layer 3 mode is enabled by default on the Citrix ADC.
The Citrix ADC will __________ the packets in this scenario. (Choose the correct option to complete the sentence.)
- A. process
- B. drop
- C. bridge
- D. route
Answer: D
NEW QUESTION 35
Scenario: A Citrix Administrator made changes to a Citrix ADC, deleting parts of the configuration and saving some new ones. The changes caused an outage that needs to be resolved as quickly as possible. There is no Citrix ADC backup.
What does the administrator need to do to recover the configuration quickly?
- A. Restart the Citrix ADC.
- B. Run saved versus running configuration.
- C. Run highly availability (HA) file synchronization.
- D. Restore from the revision history.
Answer: D
NEW QUESTION 36
Scenario: A Citrix Administrator manages an environment that has three SSL websites, all serving the same content.
www.company.com
www.company.net
www.company.org
The administrator would like to consolidate the websites into a single, load-balanced SSL vServer.
What can the administrator bind to use a single SSL vServer?
- A. A wildcard certificate to a single SSL vServer
- B. A multiple SAN certificate to a single SSL vServer
- C. The certificate of each website to a single SSL vServer
- D. A wildcard certificate to a content-switching vServer
Answer: C
NEW QUESTION 37
Scenario: The primary content switching vServer has gone down. To troubleshoot, a Citrix Administrator has issued the following command:
> show csvserver CSV
CSV (10.1.100.100:443) - HTTPS Type: CONTENT
State: UP
Last state change was at Mon Jun 29 15:20:43 2020
Time since last state change: 1 day, 06:47:58 610
Client Idle Timeout: 180 sec
Down state flush: ENABLED
Disable Primary vServer On Down: DISABLED
Appflow logging: ENABLED
Port Rewrite: DISABLED
State Update: DISABLED
Default: Content Precedence: URL
vServer IP and Port insertion: OFF
Persistence: NONE redirect: http://www.site1.com/mysite1/maintenance
Backup: vServer-LB-2
Listen Policy: NONE
IcmpResponse: PASSIVE
RHIstate: PASSIVE
Traffic Domain: 0
Based on this output, where will the subsequent request be redirected?
- A. vServer-LB-2
- B. 10.1.100.100:443
- C. http://www.site1.com/mysite1/maintenance
- D. Backup content switching vServer
Answer: C
NEW QUESTION 38
Which two policies can a Citrix Administrator configure using only the advanced policy expression? (Choose two.)
- A. DNS
- B. System
- C. Integrated caching
- D. SSL
Answer: A,C
Explanation:
Explanation/Reference: https://docs.citrix.com/en-us/citrix-adc/current-release/appexpert/policies-and-expressions/ introduction-to-policies-and-exp/classic-and-advanced-policy.html
NEW QUESTION 39
Scenario: A Citrix Administrator configured a responder policy as follows:
> add responder action Redirect_Act respondwith "DIAMETER.NEW_REDIRECT(\"aaa://host.example.com\")"
> add responder policy Redirect_Pol "diameter.req.avp(264).value.eq(\"host1.example.net\")" Redirect_Act
> bind lb vServer vs1 -policyName Redirect_Pol -priority 10 -type REQUEST What will be the effect of this configuration?
- A. Response originated from "host.example.net" will be redirected to "host1.example.com".
- B. Request originated from "host1.example.net" will be redirected to "host.example.com".
- C. Request originated from "host.example.net" will be redirected to "host1.example.com".
- D. Response originated from "host1.example.net" will be redirected to "host.example.com".
Answer: B
Explanation:
Explanation/Reference:
NEW QUESTION 40
Scenario:
POLICY 1:
add rewrite action ACT_1 corrupt_http_header Accept-Encoding
add rewrite policy POL_1 HTTPS.REQ.IS_VALID ACT_1
POLICY 2:
add rewrite action ACT_2 insert_http_header Accept-Encoding "\"identity\"" add rewrite policy POL_2 "HTTP.REQ.IS_VALID " ACT_2 How can a Citrix Administrator successfully bind the above rewrite policies to the load-balancing vServer lb_vsrv so that POL_2 is evaluated after POL_2 is evaluated?
- A. bind lb vServer lb_vsrv -policyName POL_1 -priority 90 -gotoPriorityExpression NEXT -type REQUEST bind lb vServer lb_vsrv -policyName POL_2 -priority 100 -gotoPriorityExpression END -type REQUEST
- B. bind lb vServer lb_vsrv -policyName POL_1 -priority 90 -type REQUEST bind lb vServer lb_vsrv -policyName POL_2 -priority 100 -type REQUEST
- C. bind lb vServer lb_vsrv -policyName POL_1 -priority 90 -gotoPriorityExpression END -type REQUEST bind lb vServer lb_vsrv -policyName POL_2 -priority 80 -gotoPriorityExpression NEXT -type REQUEST
- D. bind lb vServer lb_vsrv -policyName POL_1 -priority 110 -gotoPriorityExpression NEXT -type REQUEST bind lb vServer lb_vsrv -policyName POL_2 -priority 100 -gotoPriorityExpression END -type REQUEST
Answer: D
NEW QUESTION 41
A Citrix Administrator needs to configure a Citrix ADC high availability (HA) pair with each Citrix ADC in a different subnet.
What does the administrator need to do for HA to work in different subnets?
- A. Configure SyncVlan
- B. Turn on Independent Network Configuration (INC) mode.
- C. Turn on HA monitoring on all interfaces
- D. Turn on fail-safe mode.
Answer: B
Explanation:
Explanation/Reference: https://docs.citrix.com/en-us/citrix-adc/current-release/system/high-availability-introduction/ configuring-high-availability-nodes-different-subnets.html
NEW QUESTION 42
What
is the effect of the "set cs vServer-CS-1 -redirectURL http://www.newdomain.com/mysite/" command?
- A. All
the requests to vServer-CS-1 will be redirected to http://www.newdomain.com/mysite/. - B. If
the status of vServer-CS-1 is DOWN, then users will be redirected to http://www.newdomain
.com/mysite/. - C. If
the vServer-CS-1 encounters a high connection rate, then users will be redirected to
http://www.newdomain.com/mysite/. - D. All the requests without URL path/mysite/ will be redirected to http://www.newdomain.com/mysite/.
Answer: B
NEW QUESTION 43
A Citrix Administrator needs to confirm that all client certificates presented to the authentication vServer are valid until the year 2023.
Which expression can the administrator use to meet this requirement?
- A. CLIENT.SSL.ORIGIN_SERVER_CERT.VALID_NOT_AFTER.EQ(GMT2023)
- B. CLIENT.SSL.CLIENT_CERT.VALID_NOT_AFTER.EQ(GMT2023)
- C. CLIENT.SSL.CLIENT_CERT.DAYS_TO_EXPIRE.EQ(2023)
- D. CLIENT.SSL.CLIENT_CERT.VALID_NOT_BEFORE.EQ(GMT2023)
Answer: B
Explanation:
Explanation/Reference: https://docs.citrix.com/en-us/citrix-adc/current-release/ssl/ssl-actions-and-policies/config-built-in- ssl-actions.html
NEW QUESTION 44
Scenario: A company has three departments with proprietary applications that need to be load balanced on a Citrix ADC. The three department managers would like to use the same IP address to access their individual applications. This would mean configuring three load-balanced vServers, all using the same IP address.
What can the Citrix Administrator configure for this scenario?
- A. Three different Citrix ADCs that use the same IP address
- B. Three different load-balanced vServers with three different IP addresses on a Citrix ADC
- C. Three SNIPs with the same IP address on a Citrix ADC
- D. Three different admin partitions that allow use of the same IP address for each load-balanced vServer on a Citrix ADC
Answer: C
NEW QUESTION 45
Scenario: Client connections to certain vServers are abnormally high. A Citrix Administrator needs to be alerted whenever the connections pass a certain threshold.
How can the administrator use Citrix Application Delivery Management (ADM) to accomplish this?
- A. Configure TCP Insight on the Citrix ADM.
- B. Configure specific alerts for vServers using Citrix ADM.
- C. Configure network reporting on the Citrix ADM by setting the threshold and email address.
- D. Configure SMTP reporting on the Citrix ADM by adding the threshold and email address.
Answer: C
NEW QUESTION 46
Scenario: A load-balancing vServer is configured to utilize the least bandwidth load-balancing method. A service attached to this vServer is brought into the effective state during production hours.
During the startup of a vServer, which load-balancing method is used by default?
- A. Least bandwidth
- B. Custom load
- C. Least connections
- D. Round-robin
Answer: C
NEW QUESTION 47
Which step can a Citrix Administrator take to use default compression policies?
- A. Disable the Citrix ADC compression feature at a global level.
- B. Select the compression algorithm (gzip/deflate/identity).
- C. Bind the default compression policies to the vServer.
- D. Enable compression on the associated bound services.
Answer: B
Explanation:
Explanation/Reference: https://docs.citrix.com/en-us/citrix-adc/current-release/optimization/http-compression.html
NEW QUESTION 48
Scenario: Users are trying to access https://cs.mycompany.com, but are receiving the error below:
HTTP 503 Service Unavailable
What can a Citrix Administrator change in the Citrix ADC configuration to fix this?
- A. Disable the spillover redirect URL.
- B. Bind the default load-balancing vServer.
- C. Bind a certificate.
- D. Enable the content switching feature.
Answer: B
NEW QUESTION 49
Scenario: A Citrix Administrator executed the command below:
> set httpcallout httpcallout1 -cacheForSecs 120
This command changes the cache duration of the HTTP ____________ to be set to 120 seconds. (Choose the correct option to complete the sentence.)
- A. request
- B. callout request
- C. callout response
- D. response
Answer: C
NEW QUESTION 50
Scenario: A Citrix Administrator executed the command below in an active-active, global server load balancing (GSLB) setup.
set gslb parameter -ldnsprobeOrder DNS PING TCP
The order to calculate the _____ for dynamic proximity will be the DNS UDP query followed by the ping and then TCP. (Choose the correct option to complete the sentence.)
- A. Time to live (TTL)
- B. Empty Domain Service (EDS)
- C. Multiple IP responses (MIR)
- D. Round-trip time (RTT)
Answer: D
NEW QUESTION 51
......
Try 100% Updated 1Y0-241 Exam Questions [2021]: https://www.pdf4test.com/1Y0-241-dump-torrent.html
The Best CCA-AppDS 1Y0-241 Professional Exam Questions: https://drive.google.com/open?id=15DQEs-PaC4oklombJw550zX4RIoWgvEb
